Technical knowledge base
Technical papers, FAQs and case notes written to help maintenance planners and plant managers optimize asset performance.
Papers
-
How dry ice blasting works: the medium, the mechanisms and the variables that set the result
Dry ice blasting removes a deposit by particle impact, sudden cooling and the expansion of the particles as they sublime; the one quantitative split found, reported second-hand, puts the effect at 85 % mechanical and 15 % thermal at 20 °C. This paper gives the constants of the medium, the three mechanisms with the conditions…
-
Non-abrasive cleaning methods for turbine components
Dry ice blasting is non-abrasive in the sense that it uses no hard blast media and its soft medium sublimes on impact; EPRI lists the process as non-abrasive on most materials. This paper gives the sources for that, the effects measured on aluminum, steels, thin sheet, insulation and coatings with the settings behind them, and…
-
NORM in oil and gas equipment: sources, risks and regulatory framework
How naturally occurring radioactive material gets into oil and gas equipment, and who regulates it in Canada: the CNSC’s limited role, the dose-based Canadian NORM Guidelines and their release limits, the 70 Bq/g transport boundary, and what the Alberta, British Columbia and Saskatchewan instruments say.
-
Fouling and performance degradation in gas turbines: maintenance timing and methods
Compressor fouling is the main recoverable loss in a gas turbine. This paper sets out what the published sources support on wash scheduling, cold-weather washing, performance trending and dry ice blasting of compressor blading, including the problems they report.
-
Maintenance intervals and performance degradation in air-cooled heat exchangers
Fin-side fouling insulates the fins of an air cooler and restricts its airflow, and the sources reviewed give no cleaning interval or trigger threshold for process coolers. This paper sets out what they do support: how the loss arises, what a plant can trend on its own instruments to time a cleaning, and what is…
Frequently asked questions
- Will dry ice blasting damage surfaces or change tolerances?
- Can you clean electrical equipment?
- How is the removed material contained and collected?
- How do you determine if a contaminant is removable?
- How does dry ice blasting compare to water washing, solvents or abrasives?
- What performance recovery can we expect on an air-cooled exchanger, and how is it checked?
- How are cleanliness and results checked after blasting?
- What is left behind after blasting and how is waste handled?
- How quickly can you mobilize in Western Canada?
- Can you provide before/after documentation or inspections?
- How do you handle sensitive materials such as insulation, seals, gaskets and electronics?
- What are the hazards and controls, and where does the CO₂ come from?
- How does dry ice blasting work?